Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 324 / 414

20
Oil Level Sensor GASOLINE VEHICLE - ENGINE
5
7
4
M
F
34
81
1
3
M
F
34
81
532
Figure 20-9 Flywheel Nut Removal
533
Figure 20-10 Fan and Flywheel Installation
FLYWHEEL INSTALLATION
1. Wipe off any oil on tapered portions of crankshaft and flywheel (4) (Figure 20-8, Page 20-11) .
2. Insert woodruff key (10) into keyway of crankshaft. Then align groove in flywheel (4) to woodruff key (10) and
push flywheel onto crankshaft until it seats. Install and fan (7), flat washer (9), and nut (8) finger-tight.
3. Use a strap wrench (3) to keep flywheel and fan assembly (1) from turning while tightening flywheel nut to 80
ft·lb (110 N·m)
(Figure 20-10, Page 20-12) . See following CAUTION.
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to loosen.
• Be careful not to damage the fan blades. Use a strap wrench to hold flywheel. Do not place screwdriver
or pry bar between fan blades.
4. Install fan housing (2) and tighten screws (1) to 90 in·lb (10 N·m) (Figure 20-8, Page 20-11) .
OIL LEVEL SENSOR
TESTING THE OIL LEVEL SENSOR
See Oil Level Sensor on page 18-31.
OIL LEVEL SENSOR REMOVAL
1. Drain oil from engine. See Engine Oil – Gasoline Vehicle, Section 20, Page 20-2.
2. Remove flywheel. See Flywheel Removal on page 20-11.
3. Remove bolt (1) securing oil sensor wire clamp (2) to engine.
4. Disconnect oil level sensor wire (3) from wire harness (Figure 20-11, Page 20-13) .
5. Remove two bolts (4) securing oil sensor (5) in engine.
Page 20-12 2019 Precedent Villager 2 Maintenance and Service Manual