General Warnings
DISCONNECTING THE BATTERIES – ELECTRIC VEHICLES
1.
Disable the vehicle.
See Disabling the Vehicle on page 9.
2.
Place Tow/Run switch in the TOW position before disconnecting or connecting the batteries. Failure to heed
this warning could result in a battery explosion or severe personal injury.
3.
Disconnect the batteries, negative (–) cable first, as shown
(Figure 2)
.
4.
After disconnecting the batteries, wait 90 seconds for the controller capacitors to discharge.
CONNECTING THE BATTERIES – ELECTRIC VEHICLES
1.
Ensure the Tow/Run switch is in the TOW position.
2.
Connect the battery cables, positive (+) cable first.
3.
Tighten battery terminals to 110 in-lb (12.4 N·m).
4.
Coat terminals with Battery Terminal Protector Spray (CC P/N 1014305) to minimize corrosion.
TOW
RUN
2
3
4
5
6
+
1
1
(–)
(+)
3
2
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or
connecting battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
49A
Figure 2
Battery Cable Removal – 6x8-Volt Battery
Configuration
Page 10
Precedent Stretch Owner’s Manual
Summary of Contents for Precedent Stretch
