Club Car Carryall 1500 IntelliTach, Owner'S Manual

Page: 44 / 84

Attachments and Buckets
1. Raise the attachment arm (2) and tilt the bucket forward (4) (Figure 38) .
2. Push the float rocker switch to the right and the joystick forward (1) until the float is engaged (rocker switch light
will be illuminated). The attachment arm will slowly lower.
WARNING
• When using a bucket, never drive forward when the control for the attachment arm is in float position.
3. Drive backward to level loose material.
4. Pull the joystick backward (2) to unlock the attachment arm from the float position.
Backfilling
1. Lower the attachment arm (1) (Figure 39) and put the cutting edge of the bucket on the ground (4).
2. Drive forward to the edge of the hole to push the material into the hole.
3. Tilt the bucket forward (4) (Figure 39) as soon as it is past the edge of the hole.
4. If necessary, raise the attachment arm to empty the bucket.
1
2
3
4
252
Figure 39 Joystick Position – Backfilling
REMOVING AND INSTALLING THE ATTACHMENT ARM MECHANISM
When the attachment arm mechanism is not being used, it can be removed from the vehicle.
NOTE: Remove the bucket or the attachment before attempting to remove the attachment arm mechanism from
the vehicle.
Removing the Attachment Arm
NOTE: When removing the cylinders from the attachment arm or the interface, the cylinders may need to be retracted
slightly. Do not have hands in the area of the cylinders when extending or retracting the cylinders.
1. Lower the attachment arm to the ground and tilt the attachment interface forward (Figure 40) .
2. Stop the engine, put the Forward/Reverse Handle in NEUTRAL, engage the park brake, unfasten your seat
belt, and exit the vehicle.
3. Remove the retaining ring (1) and pin (2) from the attachment interface cylinder rod end, and keep the retaining
ring and pin for later use in this procedure
(Figure 41) .
Page 42 IntelliTach All-Wheel Drive Diesel Vehicle Owner’s Manual