Club Car Carryall 1500 2016, Maintenance And Service Manual

Page: 418 / 436

19
Hydraulic Pump Assembly HYDRAULIC ATTACHMENT SYSTEM
NOTE: Mark hoses for correct installation if factory markings are not found.
Contain and dispose of any leaking oil in an environmentally safe manner.
Pump Assembly Removal
1. Empty and remove cargo bed. See Cargo Bed Removal, Section 4, Page 4-12.
2. Relieve pressure. See Relieving Hydraulic System Pressure on page 19-1.
3. Set the joystick ON/OFF switch to OFF and remove driver seat.
4. Disconnect battery. See Side-Post Battery: Disconnecting the Battery – Gasoline/Diesel Vehicles on page
1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
5. Release the clamp securing the vent hose to top of clutch cover and remove hose.
6. Thoroughly clean the filler cap, reservoir, pump assembly, hose connections and the area around the pump
assembly.
7. Loosen two bolts, located under pump assembly, securing pump assembly to cradle (Figure 19-90, Page 19-45) .
8. Remove three bolts securing cradle to chassis (Figure 19-85, Page 19-44) and (Figure 19-86, Page 19-44) .
2301
Figure 19-85 Front Cradle Bolt
2302
Figure 19-86 Rear Cradle Bolts
Page 19-44 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual