![background image](http://html1.mh-extra.com/html/club-car/2009-xrt-950-4x2/2009-xrt-950-4x2_owners-manual_2626831047.webp)
Air Intake System
AIR INTAKE SYSTEM
The air filter should be inspected periodically and replaced when necessary. Filter changes should not exceed the
recommended interval.
See Periodic Service Schedule on page 34.
More frequent service may be required in
extremely dirty operating environments. In the event of a loss of power, sluggish acceleration, or a roughly running
engine, service the air filter immediately.
AIR FILTER REPLACEMENT – STANDARD SYSTEM
Air Filter Removal
1.
Raise the cargo bed, remove the center plastic access panel (1)
(Figure 21)
and locate the air filter housing.
2.
Release both housing retaining clips
(Figure 32)
.
3.
Lift the housing cover up off of the air filter housing.
4.
Remove knob (1) and plate (2). Carefully remove the foam pre-cleaner (3) and air filter cartridge (4) assembly to
prevent debris from entering carburetor.
See following NOTE.
NOTE:
To clean foam pre-cleaner, separate it from cartridge and wash in liquid detergent and water. Squeeze dry
in a clean cloth. The air filter cartridge and foam pre-cleaner are specifically designed for this engine. Use
only engine-compatible air filter cartridges and foam pre-cleaners designed for your engine. Do not oil
the foam pre-cleaner.
2
3
4
1
817
Figure 32
Air Filter – Standard System
Air Filter Installation
1.
Reassemble clean (or new) pre-cleaner on clean (or new) cartridge.
2.
Place the air cleaner assembly into the air filter housing.
3.
Place the housing cover on the top of the air filter housing.
4.
Secure the housing cover with both retaining clips.
5.
Replace the center plastic access panel (1)
(Figure 21)
and lower and latch the cargo bed.
2009-2011 XRT 950 Gasoline Vehicle Owner’s Manual
Page 45