Clover D14A, Service Manual

Page: 6 / 14

Updated on 18 March, 2010
- 6 -
4. INSTALLATION PROCEDURES
A. Install drip tray below faucet.
B. Thoroughly clean the dual float valve, the cooling tank and baffle. The dual float valve and baffle must be in
exact place for proper cooling operation.
CAUTION: IF THE COLD WATER BAFFLE IS REMOVED, COLD WATER WILL NOT BE FORMED NOR DISCHARGED.
C. Connect the supply water hose to cold water piping of the
back of the product.
- Connect the supply water pipe to water inlet at the back
of the product.
- Use potable water only.
- Acceptable supply water pressure is 20 ~ 100psi.
- Press reset button if cold water does not flow.
- Once all the requirements above are met, open the tap
water valve.
CAUTION: TO PREVENT PROPERTY DAMAGE DUE TO WATER LEAKAGE, SEEK INSPECTION BY PLUMBERS TO
SEE THE WATER PRESSURE IS LESS THAN 100PSI (690KPA) BEFORE YOU CONNECT THE SUPPLY WATER
HOSE.
D. For hot water activation, stay holding down hot faucet handle until water flow is continuous and clear.
E. Place the hot water switch on the "ON" position.
(Check the available power supply against the cooler specification plate to ensure correct electrical service.)
F. Cooler will be ready to serve you Cold & Hot water in 30 minute after installation.
G. Hot Water Safety Faucet: A safety faucet deters accidental dispensing of water by toddlers. (Korea, US
patented)
CAUTION: WATER FROM HOT FAUCET IS EXTREMELY HOT AND MAY SCALD.
CAUTION: FAILURE TO ABIDE BY ABOVE PROCEDURE CAN CAUSE PHYSICAL DAMAGE ON THE COOLER.
5. STORAGE
A. Close off the adapter valve to cut flow from main water pipe.
B. Switch off hot water switch.
C. Unplug power cord.
D. Disconnect the water pipe from the product.
E. Drain hot water by opening faucet. Then, do the same on cold water faucet.
F. Place a bucket behind the drain pipe. By unscrewing the drain cap counter clockwise, drain the remaining
water in the hot water tank. When tank is emptied, dry drain cap and end of drain pipe. Close draining pipe
with cap.