6
NOTE: If yOU NEEd TO dISCONNECT ThE
SPRING PlUG fROm ThE WINdING UNIT
TAkE ExTRA CARE. To remove the spring
from the winding unit, two small flat-headed
screwdrivers will be required. Two tabs must
be released, but only one tab is accessible at
a time. depress the accessible tab with a small
screwdriver. To prevent the tab from re-lock-
ing, place a second screwdriver between the
spring plug and winding unit near the released
tab. Wind the winding unit until the other tab
can be accessed. depress the second tab with
a small screwdriver. make sure both tabs have
been released. Gently pull the spring from
the winding unit.
After all of the components are on the tube, the
spring plug should be inserted into the winding
unit. Ensure that the spring plug and the winding
unit have the same color code before snapping
them together. Line up both ears on the spring
plug with the two slots in the winding unit and
push them together. (Figure 9, Views B, C and D)
Slide the components toward the center of
the tube to expose 1" of each end of the tube.
make sure that both ears of the spring plug are
fully intact and engaged into the winding unit
slots. Be certain that both of the tabs in the
winding unit slot engage with the spring plug
and that the connection between the spring
plug and the winding unit is secure before
proceeding.
fig. 9
VIEW B
VIEW C
Winding Unit label
left Side (Green)
left Side Spring
Plug Ear (Green)
VIEW d
Winding Unit
Slots & Tabs
Winding Unit label
Right Side (Orange)
Right Side Spring
Plug Ear (Orange)
Winding Unit
Slots & Tabs
lEfT SIdE ShOWN
AfTER INSERTION
RIGhT SIdE ShOWN
BEfORE INSERTION
lEfT SIdE ShOWN
BEfORE INSERTION
Tabs
(Press here
to Remove) Spring
Plug
Winding
Unit
Spring
VIEW A
