Clockaudio CCRM 4000, Installation And User Manual

Page: 13 / 32

V2.1 2021-01 Page 7 of 25
14.
Push the free end of the cable harness through
one of the holes located on the Gripper. Now
loop the free end of the cable over a secure
fixing such as a ceiling truss, eye bolt, or any
structure capable of taking 7Kgs of weight.
Now pass the cable through the remaining hole
in the Gripper and then pull on the cable to
adjust / take up the slack. Do the same with
the other Y cable at the other end of the ceiling
tile bracket.
Cable can be slackened or removed by
inserting the supplied release key into the hole
as shown.
15.
Knuckle Joint adjustment:
After installation has been completed it is
important to operate the unit a few times to
allow the cable to settle and find its natural
final rest position. The microphone can then be
aligned correctly and the knuckle joint angle
positioned for best audio reception.
Important: The microphone angle is limited to
40 degrees from vertical as shown.
NOTE: If the cable hits an obstruction such as a
desk / floor or is held preventing the upward
motion (0.5lbs pull) of the cable motor will
immediately stop. Remove the obstruction and
then press the up button on the remote, or up
command if using a DSP. The unit can now be
operated normally. Should this fail to restore
normal operation disconnect and reconnect
the supply Voltage to the CCRM 4000.
Insert release key
into hole
Gripper