CLIVET MSAN-XMi 120T Installation And Owner'S Manual Download Page 10

Page: 10 / 92

All the pictures in this manual are for explanation purpose only.
They may be slightly different from the air conditioner you
purchased(depend on model).The actual shape shall prevail.

NOTE

3.3 Moving and installation

Fig.3-7

Do not touch the fan with hands or other objects.

Do not lean it more than 45°, and do not lay it sidelong.

Make concrete foundation according to the sepecifications of
the outdoor units.(refer to Fig.3-7)

Fasten the feet of this unit with bolts firmly to prevent it from
collapsing in case of earthquake or strong wind.
(refer to Fig.3-7)

Since the gravity center of the unit is not at its physical center,
so please be careful when lifting it with a sling.

Never hold the inlet of the outdoor unit to prevent it from
deforming.

Table 4-1

The indoor and outdoor connecting pipe interface and power
line outlet

3.4 Water Outlet

Vavious piping and viring patterns can be selected,such as out from
the front ,the back the side ,and undersurface, etc.

The follow display

the locations of several piping and wiring knock-off interfaces

Front out pipe

Back out pipe

Side out pipe

Undersurface out pipe

To prevent the refrigerant piping from oxidizing inside when
welding, it is necessary to charge nitrogen, or oxide will chock
the circulation system.

CAUTION

4. INSTALL THE CONNECTING PIPE

Check whether the height drop between the indoor unit and
outdoor unit, the length of refrigerant pipe, and the number of
the bends meet the following requirements:

4.1 Refrigerant piping

Fat pipe

Four condensed water outlets on the chassis for selection
display as the follow figure:

Please pay attention to avoid the components while connect to
the connecting pipes.

While installing the outdoor unit, pay attention to the installation
place and the drainage pattern;
if it’s installed at the alpine zone, the frozen condensed water will
block up the water outlet, please pull out the rubber stopper of the
reserve water outlet. If that still fails to satisfy for the water draining,
please knock open the other two water outlets, and keep the water
can drain in time.
Pay attention to the knock the reserve water outlet from outside to
inside, and it will be beyond repair after knocking open, please pay
attention to the installation place, lest cause the inconvenience.
Please do the moth proofing for the knocked out hole, to avoid the
pest processing into and destroy the components.

CAUTION

Side out pipe: please remove the L-shape metal plate, otherwise
can not wiring.
Back out pipe:please wipe off the piping support rubber blanket
beside the inner outlet pipe cover of the machine while back side
getting out pipes.
Front out pipe: cut the frontal hole of the pipe-outlet plate.The
method of the out pipe in the same way of the back out pipe.
Undersurface outlet pipe: the knock out should from inside to
outside, and then piping and wiring through this.Pay attention to the
piping the fat connecting pipe should out from the largest hole,
otherwise the pipes will be rubbed. Please do the moth proofing for
the knocked out hole, to avoid the pest processing into and destroy
the components.

CAUTION

Use soap water or leak detector to check every joint whether leak or
not (Refer to Fig.4-2).Note:
A is low pressure side stop valve
B is high pressure side stop valve
C and D is connecting pipes interface of indoor and outdoor units

4.2 Leak Detection

Fig.3-8

Reserve water outlet

Water Outlet

Outlet for power and connecting pipes

(Need to knock open)

(With rubber stopper)

60c

Fix with bolt

Fig.4-1

Strong
wind

06$1;0L07