CS 3-Phase Installation Manual
Page 8
In Case of Difficulty
ClipperCreek recognizes that this EVSE will be heavily relied
upon to charge the electric vehicle for daily transportation needs.
Therefore, every effort will be made to restore service should
problems arise.
In the event of a problem, charging will stop and the Red
PROTECTION light will turn on. If this happens, please try the two
simple steps below before calling a Service Representative.
1. Remove the connector from the vehicle socket. The Red
PROTECTION light may turn off. If it
does
turn off, plug the
connector back into the vehicle socket, and verify that charging
begins normally.
2. If the Red PROTECTION light does not
turn off when the
connector is removed, be sure the connector is removed from
the vehicle socket and switch off power at the circuit breaker
to the CS 3-Phase. Wait a few seconds and switch the circuit
breaker back on. Reconnect the cable to the vehicle. Charging
should begin normally.
If charging does not begin, or if the Red PROTECTION light
turns on, call a Service Representative at 1-877-694-4194. The
information gained by the above steps will help the Service
Representative diagnose the problem and get the CS 3-Phase
operational again as quickly as possible.
Table 1. Front Panel Indicators
Status of CS 3-Phase
OFF
OFF
ON
OFF
OFF
ON
ON
ON
OFF