Clipper NORTON JUMBO 651 HONDA, Operating Instructions Manual

Page: 20 / 24

20
7 Faults: causes and cures
7.1 Fault-finding procedures
Should any fault occur during the use of the machine, turn it off.
7.2 Trouble-shooting guide
Trouble Possible source Resolution
Not enough fuel Fill fuel tank
Fuel filter clogged Clean fuel filter
Spark plug faulty Inspect spark plug
Hard starting
Stronger fault Contact nearest engine
maintenance centre
Blade is not turning Belts not tightened or defective Check the belts tension and
change them if needed
Air filter restricted Clean or replace air filter Engine lacks power
Stronger fault Contact nearest engine
maintenance centre
Not enough water in the pan Refill the water pan
Water tap is closed Open tap on blade guard
Water supply system is blocked up Clean water supply system
No water on the blade
Water pump is not working
•
Check if pump pulley is driven
by the belts
•
Change the pump
7.3 Customer service
When ordering spare parts, please mention:
•
The serial number (7 digits).
•
The code of the part.
•
The exact denomination.
•
The number of parts required.
•
The delivery address.
•
Please indicate clearly the means of transportation required such as "express" or "by air".
Without specific instructions, we will forward the parts through the means which seem
appropriate to us --- but which is not always the quickest way.
Clear instructions will avoid problems and faulty deliveries. If not sure, please send us the defective
part. In the case of a warranty claim, the part must always be returned for evaluation. Spare parts
for the motor can be ordered with the manufacturer of the motor or with their dealer, which is often
quicker and cheaper.
This machine has been manufactured by Saint-Gobain Abrasives S.A.
190, Bd. J.F. Kennedy
L- 4930 BASCHARAGE
Grand-Duché de Luxembourg.
Tel. : 00352-50401-1
Fax : 00352- 50 16 33
http://www.construction.norton.eu
e-mail: sales.nlx@saint-gobain.com