27
Raise
Levantar
RPM/Hours (RPM/Horas)
Lower
Bajar
Foward
Adelante
Reverse
Reversa
3600 RPM
Ignition
Ignicion
Emergency
Stop
Paro de
Emergencia
Transmission
Transmisión
Blade Dia
Eng rpm
Eng Pulley
Diameter
Blade Shaft
RPM
Blade Shaft
Pulley Dia
Diametro de
Disco
Motor rpm Diámetro en
Polea Moto
r
Flecha Disco
RPM
Diámetro en
Polea de
Flecha Disco
16" (406mm) 3,600 rpm 3.15" (80mm)
2,520 rpm
4.5" (114mm)
16" (406mm) 3,600 rpm 3.15" (80mm)
2,520 rpm
4.5" (114mm)
20" (508mm) 3,600 rpm 3.15" (80mm)
2,520 rpm
4.5" (114mm)
24" (609mm) 3,600 rpm 2.65" (67mm)
2,120 rpm
4.5" (114mm)
Blade Speed Chart
Tabla de Velocidad
Del Disco
Throttle
Acelerador
Speed Control Lever:
The operator’s right hand lever is the speed control lever. Pushing the
lever slowly forward will increase the forward speed of the saw. Pulling it
to the center will place the saw in neutral. Pulling the saw to the rear of
the console (from the neutral) will increase the reverse speed.
The Speed Control Cable may need adjustment over time due to cable
stretch. To adjust place the Speed Control:
1. With the machine running and the Transmission Engaged move the
Speed Control Lever unit the Neutral Position is found.
2. Turn the engine off and disconnect the number one cylinder’s spark
plug.
3. Loosen the set screw that attaches the Speed Control Cable to the
Transmission Control Lever. For the location of the Transmission
Control Lever see item #20 in the exploded parts diagrams
C13xx,
and C20xx Transmission
on page 37.
Do not move the
transmission control lever.
4. Reposition the Speed Control Lever so that the Speed Control Lever is
in the center of the slot.
Do not move the transmission control
lever.
5. Tighten the set screw the Speed Control Cable to the Transmission
Control Lever.
Do not move the transmission control lever.
6. Replace the number one cylinder spark plug.
Transmission
Engage/Disengage Lever
Speed
Control Lever
Engine
Throttle
