15
E. Controls
Raise
Levantar
RPM/Hours (RPM/Horas)
Lower
Bajar
Foward
Adelante
Reverse
Reversa
3600 RPM
Ignition
Ignicion
Emergency
Stop
Paro de
Emergencia
Transmission
Transmisión
Blade Dia
Eng rpm
Eng Pulley
Diameter
Blade Shaft
RPM
Blade Shaft
Pulley Dia
Diametro de
Disco
Motor rpm Diámetro en
Polea Moto
r
Flecha Disco
RPM
Diámetro en
Polea de
Flecha Disco
16" (406mm) 3,600 rpm 3.15" (80mm)
2,520 rpm
4.5" (114mm)
16" (406mm) 3,600 rpm 3.15" (80mm)
2,520 rpm
4.5" (114mm)
20" (508mm) 3,600 rpm 3.15" (80mm)
2,520 rpm
4.5" (114mm)
24" (609mm) 3,600 rpm 2.65" (67mm)
2,120 rpm
4.5" (114mm)
Blade Speed Chart
Tabla de Velocidad
Del Disco
Throttle
Acelerador
Depth Control Hand Wheel:
Controls the cutting depth of the blade. Rotate Clockwise to raise and
counter clockwise to lower the depth of cut.
Fuel Tank (20 HP Only):
An internal all metal fuel tank is standard equipment for 20 HP models
only (C2016, C2020, C2024, PC2016, PC2020,and PC2024). All 13 HP
models have a fuel tank attached to the top of the engine. To fill the Fuel
Tank remove the Fuel Cap slowly, fill tank to approximately 1-½” below
the bottom of the Fuel Tank Neck and reattach the Fuel Cap. Do not over
fill the tank. Avoid fuel spills and contact with fuel. Only re-fuel in well
ventilated areas and way from sparks and open flames.
Tachometer/Hour Meter
Emergency Kill
Switch
Fuel Tank
20 HP ONLY
Transmission
Engage/Disengage Lever
Speed
Control Lever
Engine
Throttle
Engine Ignition
Switch
Depth Control
Hand Wheel
Choke
20 HP ONLY
