Filter Changing Procedure
Never operate the Clipper VAC® without the filter on the motor. When ordering filters, be sure
to specify that your filter is held in place by a nut.
1. Unplug the Clipper Vac system.
2. Open the lower compartment.
3. Remove the wing nut under filter.
4. Pull filter downward and remove.
5. Clean area where filter contacts the motor.
6. Install new filter and replace the nut. Make sure the filter is pressed tightly against the shelf
or hair will enter the motor. Do not over tighten the nut.
7.
Tighten the wing nut.
Filters are designed especially for Clipper VAC® and may be purchased from M.D.C. Romani, Inc.