BACKREST CYLINDER REPLACEMENT
(models 85200, 85300 & 85309 only)
Remove cotter pin. Then remove
the slide-out pin. Position tab locat-
ed on the adjustment bar against
cylinder pin.
Align holes in cylinder bracket with holes in table bracket by adjusting
the angle until the holes line up. Install slide-out pin through holes and
replace cotter pin.
Finished view of cylinder assembly.
The backrest cylinder is replaceable in the field by following these simple directions below.
STIRRUPS
(model 85309 only)
Stirrups are shown in the stored position in photo below at left. When extended, stirrups have two width
positions. Position 1 is the narrowest and Position 2 the widest. The length of the stirrups can be adjusted by
moving the stirrup slider to the desired location. When the patient applies foot pressure to the stirrup, it will
automatically lock into position. To return the stirrups to the stored position, fold the stirrup over onto the
slider bar and slide BOTH towards the head end of the table. The stirrup will store under the upholstered top.
ADJUSTMENTS
(continued)
Stirrup
Stirrup
Slider
Stirrups in the stored position
Stirrup positions
Stirrup Position 1
Stirrup Position 2
Cylinder Pin
Tab