-- 11 --
To go to the next group, press the “ARROW-ROUND” button again
The next group is:
Test Motor (Balance)
This test allows testing the “balance” of the motor. If this adjustment is not
correct, the motor turns hot while operating.
To perform the test the motor has to be disconnected from the machine.
Push the NU/ND- button, the motor starts running with a low speed (100 rpm) for
about three revolutions. The display reads:
“WAITING FOR INDEX”
After the motor stops, the following message will be displayed:
“CALCULATE OFFSET”
. When the offset is calculated, the result will be
displayed:
“ADJUSTMENT: + xx “
or
“ADJUSTMENT – xx”
“+xx” or “- xx”
represents a number. This number should not be higher then 15.
If the reading is not correct, please repeat the test (Press NU/ND again).
(5.6 encoder counts is one degree).
Description of:
Inputs:
Function
Location
Pin Number
Photo Eye
LCD- box, Phone plug
Manual Cut
6- pin plug 2 & 4
Outputs:
Function
Location
Pin Number
Presser Foot
2 2-pin plug 1&2
Venturi / Waste/ Mot. Run
9-pin plug 1&4
Venturi
9-pin plug
2&5
Impact Cutter
9-pin plug
3&6
