12
Based on Software Version 1.31.1. Content subject to change without notice. Check www.clintonelectronics.com for the most current manual.
Step 3.
If you are configuring the network proxy after
the unit has been on-boarded, (already has a network
connection) begin by pressing the
Menu
key on the
remote.
Step 1.
If you are configuring the network proxy during
on-boarding, start here. Otherwise proceed to
Step 3
.
Connect to your network via WIFI or ethernet cable.
The PVM will attempt to test the connection, which will
fail because the proxy is not yet configured.
Step 4.
Use the arrow keys to move down and select
the
Network
button.
Step 2.
Use the arrow keys on the remote to select
the
CONFIGURE PROXY
button and press
ENTER
.
Continue with the instructions at
Step 6
.
Connect PVMs support network proxies as a means of connecting to the internet. Below are the steps to configure the
network proxy.
ATTENTION:
Network Proxy settings must first be configured. If the settings are not set up on the
network before following these steps, the Connect PVM will not connect to the network.
NETWORK /
Proxy Configuration
