Note
Climinox
published on 01/01/2011
(this document can be modified without notice)
Wall or ceiling mount:
Frame mounted on the
floor:
In order to allow for expansion of the layers, the extension bolts have
to be tightened moderately.
Only the nuts that tighten the frame, the ventilation module or the
attaching crosspiece of the pan have to be locked in order to prevent the
unit from becoming unscrewed.
4 - Connections of the layers:
Each installation is unique. To meet the flow rates and load losses, specific
to each one, it is necessary to establish a different hydraulic circuit.
A connection diagram is therefore established and provided with each air conditioner,
for the application for which it is intended.
The layers are connected together by a system of connectors. Each connector is
fastened by a special through-bolt, a washer and a nut. The seal is provided by O-ring
seals and retaining rings.
Vertical connections to be used:
- Short connectors
- Ø 8/85 connector bolts
- Ø 8 flat washers and nuts
Seal to be used:
- Ø25x5x35 O-ring seals
- Ø 38x1.5 retaining rings
8
/ 14
