Note
Climinox
published on 01/01/2011
(this document can be modified without notice)
Case with mounting on the wall:
Assemble the splashback with the triangular plate and the stand
carrier crosspiece.
Fasten the wall consoles onto the plates of the machine. Use
ø8 washers and nuts
Case with mounting on the floor:
Assemble the frame by fastening the stringers on each side of
the end frames.
Use ø8x20 bolts, ø8 washers and nuts.
The support lugs for the gates must be positioned
outwards.
OR
via the ventilation module in the case of a frame model on
the floor.
2 - Installing the frame:
The frame must then be installed definitively. Complete assembly, before its final
destination, would make the unit difficult to handle.
Use ø10 washers and lock nuts to attached the air conditioner to the wall or to the
ceiling.
Place the PEHD plates under the feed for a floor mount. Check the level before
continuing with the assembly.
3 - Installation of tubular layers to form the batteries
Use the starting bolts to fasten the first row of layers
to the frame.
The short extension bolts to fasten the intermediate rows.
The long extension bolts to fasten the last row.
Finally, finish with the crosspiece for attaching the condensate pan.
7
/ 14
