climecon.fi
© Climecon
6
Installation manual ECO-T, controller
21
.0
1
2
4
3
230VAC
CONTROL
Modbus
TERMINATION
OFF-ON
DIP1-8:
Modbus-ID
L
N
N
L
X3
X2
X1
OFF/ON
D- D+ V
T
B A
CONTROL BUS
T
Figure 1.1
Figure 2.1
Figure 3.1
3. Start-up guide
1.
Connect the supply voltage to the system,
which will activate the touch screen’s main view
(Figure 3.1).
2.
Enter the main menu by pressing
in the top left corner of the screen.
3.
Set the language, date and time.
4.
You can change the language by navigating to the
Language section in the Display settings menu.
Return to the previous view by pressing .
5.
The date and time can be set in
the Date & Time section.
6.
To return to the main view, press again
the icon in the top left corner.
7.
The temperature can be adjusted in the main
view with the plus and minus symbols.
8.
More detailed instructions on the system
functions are provided in a separate manual.
2. Controller installation:
1.
Run the ECO-T controller unit’s data cable
from the ECO air heater to the junction box,
as shown in Figure 2.1.
2.
Detach the touch screen (4) from the locking
piece (3).
3.
Detach the locking piece from the bottom (1),
for example with a small screwdriver.
4.
Fasten the bottom (1) to the junction box.
5.
Install the cover plate (2).
6.
Install the locking piece (3).
7.
Connect the wires to the touch screen
connectors, as shown in Figure 2.1.
8.
Push the touch screen (4) into the locking piece
(3) until you hear a click.
1. Components of the ECO-T controller
1.
Bottom
2.
Cover plate
3.
Locking piece
4.
Touch screen
More comprehensive instructions
for adjusting and scheduling room
temperature can be found via the
QR code or at
climecon.fi/eco
