www.climecon.fi
© Climecon
3
Lämmittäjänkatu 4 A, FI-00880 HELSINKI, Finland · Tel358 20 198 6600, Fax +358 020 198 6609
1. GENERAL
These are the installation, adjustment and maintenance instructions for Climecon CleanMas-
ter® hoods.
The model range of Climecon CleanMaster® hoods includes:
• CleanMaster® hoods
• CleanMaster® hoods with capture air
• CleanMaster® hoods with supply air and capture air
Make sure you read and understand these installation, adjustment and maintenance instruc-
tions before starting to install and use the product. If you have any questions about the instal-
lation or operation of the product, please contact the Climecon customer service.
Climecon Oy
Lämmittäjänkatu 4 A
00880 HELSINKI
Puh 020 198 6600
Fax 020 198 6609
1.1 Safety at work and safe installation of the product
Failure to observe these operating and safety instructions during operation, disregarding
these instructions or using the UV equipment not as specified can result in injuries!
NOTE!
The electrical connection of the CleanMaster® system may only be carried out by an
authorized electrician. Warranty is subject to the condition of using Climecon spare parts and
UV lamps. Only the original parts or the spare parts or UV lamps ordered from Climecon may
be used in the device. The UV lamps should always be ordered from Climecon customer service
(tel. 020 198 6600).
Ultraviolet radiation and ozone are hazardous to health!
The areas which are especially
exposed to the ultraviolet radiation are the skin and eyes. The radiation can cause burns and a
long-term exposure can result in a cataract.
Always make sure that the UV lamps are turned
off when removing the grease filters!
ALWAYS
wear safety goggles and safety gloves during installation for protection against
quartz fragments, which can become scattered around if the UV lamp breaks.
1.2 Receiving the goods
Check that the delivered product batch is according to your order and all the parts stated in
the delivery note are included. The carrier of the cargo should be informed immediately about
errors in the delivery and incorrect delivery as well as possible damages occurred during tran-
sportation, and the respective notice should also be sent to Climecon or the distributor.
The term of notice is 5 days from delivery. Climecon Oy shall take no responsibility for costs
arising from the replacement of products, which had not been installed according to the instal-
lation instructions.
In case of problems you should contact the Climecon customer service!