www.climecon.fi
© Climecon
19
Lämmittäjänkatu 4 A, FI-00880 HELSINKI, Finland · Tel358 20 198 6600, Fax +358 020 198 6609
Switch on the CleanMaster
®
system from the operating
switch of the CCM control
unit.
Lock the SlideSafe safety lock by first lifting the hand screws
to the upper position and then tightening the screws. NOTE!
The CleanMaster
®
system will not start, when the SlideSafe
safety lock has not been properly locked.
Install all the grease filters back into
the hood. First install the grease fil-
ters at far edges, leaving the second
grease filter from the left as the last.
Attach the electrical connec-
tor (quick connector) of the
UV lamp to the ceiling of the
hood and tighten clockwise.
Mount the new UV
lamp to the holders and
tighten the hand screws
clockwise.
Replace the UV lamp with
a new lamp. Only Climecon
UV lamps may be used in the
CleanMaster
®
system. Order
the new UV lamp from the
Climecon customer service.
Deliver the old UV
lamp to the recycling
station of fluorescent
lamps.
Turn the hand screws of
the supports of the UV
lamp counter clockwise
and remove the UV lamp
from the supports.
Shut down the CleanMaster
®
system
by turning the main switch of the
CCM control unit to OFF position.
Open the SlideSafe safety lock by loosening the
hand screws and moving these to the lower position.
Move the grease filter on the
far left to the left.
First remove the second grease fil-
ter from the left and then the other
grease filters.
Remove the electrical connec-
tor (quick connector) of the UV
lamp from the ceiling of the
hood by turning the connector
counter clockwise.
Always when in doubt,
contact the Climecon
customer service by calling
020 198 6600.
7
6.4 Replacing the UV lamp
2
3
1
4
8
12
13
9
10
11
5
6
