Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 68 / 132

Page 50 ODF Speed Facer Operating Manual
4. Loosen the jam nut and unscrew the adjusting
bolt to free the cable from the feedbox.
5. Loosen the Velcro straps to free the protective
cable conduit, remove and put aside.
Do the following on the trip actuator:
1. Remove the cover plate.
2. Lift the barrel end of the cable up and out of
the trip arm and the cable out of the slot in the
actuator block.
F
IGURE
5-8. B
ARREL END OF CABLE REMOVAL
(
LEFT
); C
ABLE AND HOUSING CUT
-
TERS
(
RIGHT
)
5.3.9.2 Cable preparation
Do the following to prepare the cable:
1. The use of a cable and jacket cutter is sug-
gested (ParkTool #CN-10).
2. Cut only the cable jacket to the following
length according to the ODF Speed Facer model:
•
ODF30: 22" (55.8 cm)
• ODF40: 30.5" (77.5 cm)
• ODF50: 38.5" (97.8 cm)
• ODF60: 38.5" (978 mm)
• ODF70: 44" (1,118 mm)
• ODF80 and larger: and 60" (1,524 mm)
T
IP
:
Even with the use of a cable and jacket cutter,
pinching of the internal jacket may occur. If it
does, ream out with an awl or scribe before
installing the cable. Install ferrules on both
ends of the cable jacket by crimping.
3. Thread the spring onto the cable and up against
the barrel end.
4. Thread the cable through the cable jacket.
F
IGURE
5-9. B
ARREL END OF CABLE WITH SPRING
,
FERRULE INSTALLED ON CABLE
HOUSING
(
LEFT
);
CABLE INSTALLED IN ACTUATOR HOUSING
(
RIGHT
)
5.3.9.3 Cable installation
To install the cable, do the following on the trip actua-
tor (see Figure 5-9-right):
1. Install the barrel end of the cable into the
pocket on the trip arm.
2. Trap the spring between the trip arm and the
actuator body.
3. Insert the cable into the slot of the actuator
body.
4. Reinstall the protective cable conduit over the
trip cable.
Do the following on the feedbox:
1. Thread the cable free cable end through the
90° elbow, adjusting bolt and jam nut.
2. Screw the jam nut onto the adjusting bolt.
3. Set the adjusting bolt approximately halfway
into the feedbox housing.
4. To determine the final length of the cable, take
up the slack until the trip actuator arm is 90° to
the trip actuator body. Trim the cable even with
the far side of the feedbox wall.
F
IGURE
5-10. 90°
ELBOW
,
ADJUSTING NUT AND JAM NUT
(
LEFT
);
CABLE END
SHOWN AT TRIMMING LOCATION
(
RIGHT
)