Clifford ACE 2000, Installation Manual

Page: 19 / 25

Installer- Programmable Fea tures
To access the installer-programmable features, use the procedure defined in the
User-Programmable section, but after completing step 4, continue to press and hold the
✱
side of the PlainView 2 Switch for another 10 seconds. You will hear three confirmation
chirps indicating that the system is in installer-program mode.
Table of Installer-Programmable Features: 1 chirp = OFF, 2 chirps = ON.
Fea ture Select Unmarked 1 Unmarked 2 Unmarked 3
✱
1
Single /Double
Lock Pulse
( 1 chirp /2 chirps)
Auxilliary A
Timer Duration
(10 Seconds)
NOTE 1
Door Ajar
Warning /Delayed
Courtesy Lights
( 1 chirp /2 chirps)
✱
2
Single /Double
Unlock Pulse
( 1 chirp /2 chirps)
Auxiliary A type
( Pulsed /Timed/Latched)
( 1 chirp /2 chirps/3
chirps)
Auxiliary A Interlock
(On/
Off
)
✱
3
Lock/Unlock Pulse
1 sec./ 3 sec.
( 1 chirp /2 chirps)
NOT USED NOT USED
✱
4
Door Lock Polarity
Positive /Negative
(1 chirp/
2 chirps
)
Diesel Engine /Gas
Engine
(1 chirp/ 2 chirps )
(Requires Optional
IntelliStart 4)
AutoActivate Auxiliary
A
(On/ Off )
✱
5
Program RPM
(Requires Optional
IntelliStart 4)
Program Optional
SmartWindows 4
Program Door Polarity
(Positive/ Negative )
(1 chirp/ 2 chirps)
NOTE 1:
Once this feature is selected, you will hear one chirp to confirm that the
timer has started. You can set this anywhere from one to 4.25 minutes (255
seconds). When the desired duration has been reached, press the unmarked side of
the PlainView 2 switch. You will hear two chirps to confirm the new system timer
duration.
Sys tem Check list & Trou ble shoot ing
The fol low ing check list and trou ble shoot ing tips will as sure that you have in stalled the ACE
2000 cor rectly. If the sys tem does not re act as noted, fol low the trou ble shoot ing tip(s)
de noted with a black box be low that item, then re peat the step. Each suc ces sive step re quires
that the pre vious step has been com pleted as in di cated.
Step 1.
Re-enable the courtesy lights.
In step 1 of the Important Information sec tion (the first tabbed section) at the end of this
manual, the in te rior cour tesy lights were disabled. You must now re-enable the courtesy lights
by re placing the fuse you re moved or re set the cour tesy light switch back to its nor mal
“DOOR” po si tion bef ore pro ceed ing.
17