Click RF PiLOT, Installation Manual

Page: 14 / 25

25 24
Control - Actuator Function Control - Actuator Function
Actuator
Functions end
RFDA-73M/RGB
Dimming RGB Actuator Functions
Description
Turn On Actuator switched On
Turn Off Actuator switched Off
Brightness 0% Brightness setting within the range 0-100% (10% steps using left & right buttons)
White Switches the RGB LED’s to white
RGB With left and right on the directon dial you can select the RGB colour required and activate switching T1.
Wait approx. 1s between individual button presses.
T1
T2
Select the required function (highlighted white) using
up & down on the direction dial.
Execute the selected function by pressing T1. (If the function
selected is
Brightness % , use left & right of the dial to change
the % output which are in increments of 10%).
When selecting RGB, the coloured ribbon is shown (Fig.2). Use
left & right of the dial to move the cursor along. Press T1 to
activate the colour.
[
- Green symbol - command accepted and executed by the actuator (Fig.1)
×
- Red symbol - Error - see page 39
To access the control screen, see page 20
tu 01.03.11 12:54
Turn On [
Turn Off
Brightness: 0%
White
RGB
BACK PROCEED
Fig.1
T1
T2
tu 01.03.11 12:54
Turn On
Turn Off
Brightness: 0%
White
RGB
BACK PROCEED
Fig. 2
T1
T2
T1
T2
Select the required function (highlighted white) using
up & down on the direction dial.
Execute the selected function by pressing T1.
[
- Green symbol - command accepted and executed by the actuator (Fig.1)
×
- Red symbol - Error (Fig.2) - see page 39
To access the control screen, see page 20
tu 01.03.11 12:54
Up [
Down
Turn up
Turn down
Setting
BACK PROCEED
Fig.1
tu 01.03.11 12:54
Up
×
Down
Turn up
Turn down
Setting
BACK PROCEED
Fig. 2
RFJA-12
Blind/Shutter Actuator Functions
Description
Up Device moves up to end position
Down Device moves down to end position
Turn up Rolling the blinds/shutters up in gradual steps using short impulses
Turn down Rolling the blinds/shutters down in gradual steps using short impulses
Setting Setting the travel time of the device for Scene control. Measure the travel time from one end position to the other
end position. Set the time data + 2s in the Controller. Range 2s - 240s. After altering the Up/Down settings ‘SAVE’
must be pressed for each element altered.
The actuator must be powered and within communication range else an error will occur.