CLF POSEIDON Wash XL, Manual, Page: 7 / 38

Introduction
powerful outdoor Wash
Using for the first time
Warning! Read “Safety Information” before installing, powering, operating or servicing the fixture. Before applying
power to the fixture:
Check that the local AC mains power source is within the power voltage and frequency ranges of the fixture
See “Power cables and power plug”. Install a PowerCON TRUE1 ® power input connector power cable.
AC POWER
▪
▪
▪
▪
▪
Warning! Read “Safety Information” starting on before connecting the fixtures to AC mains power.
Warning! For protection from electric shock, the fixture must be grounded (earthed). The power distribution circuit must
be equipped with a fuse or circuit breaker and ground-fault (earth-fault) protection.
Warning! Socket outlets or external power switches used to supply the fixture with power must be located near the
fixture and easily accessible so that the fixtures can easily be disconnected from power.
Important! Do not insert or remove live PowerCON TRUE 1 ® connectors to apply or cut power, as this may cause arcing at
the terminals that will damage the connectors.
Important! Do not use an external dimming system to supply power to the fixture, as this may cause damage to the
fixture that is not covered by the product warranty.
The fixture can be hard wired to an electrical installation if you want to install it permanently, or a power plug that is suitable
for the local power outlets can be installed on the power cable.
Power voltage
Warning! Check that the voltage range specified on the fixture serial number label matches the local AC mains power voltage
before applying power to the fixture.
The fixtures accepts AC mains power at 100-240V nominal, 50/60 Hz. Do not apply AC mains power to the fixture at any
other voltage than specified.