WWW.CLF-LIGHTING.COM
9
Setup
Warning! Read “Safety Information” before installing, powering, operating the fixture.
Control panel and menu navigation
The
onboard control panel and backlit graphic display are used to set the fixture’s DMX address, configure individual fixture settings
(personality), read out data and execute service utilities. See “Onboard control menus” for a complete list of menus and commands.
Using the control buttons
•
To enter the menu select [MODE].
•
Press [UP] and [DOWN] to scroll within a menu or adjust values.
•
To enter a menu, select a function or apply a selection, press [ENTER].
•
To escape a function or move back one level in the menu structure, press [MODE].
DMX address setting
The
DMX address, also known as the start channel, is the first channel used to receive instructions from the controller. For independent
control, each fixture must be assigned its to a separate channel. The DMX address can be configured by using the DMX ADDRESS menu
in the control panel. For setting the DMX address press [ENTER] before you can change the address.
•
The main screen will show a ‘dot’ and the backlight will be switched off when a DMX signal is detected.
•
The
fixture is fully RDM ready. So when you are using a RDM ready console you can address the unit and read out its complete
status. For RDM functions please refer to the ANSI/ESTA E1.20-2006 standard
