Disassembly
Removing and Installing a Processor 2 - 9
2.Disassembly
Removing and Installing a Processor
Processor Removal Procedure
1.
Turn
off
the computer, remove the battery (
page 2 - 5
) and the component bay cover (
page 2 - 12
).
2.
The CPU heat sink will be visible at point
(
Figure 5a
) on the mainboard.
3.
Remove screws
,
,
,
,
,
and
, the reverse order indicated on the label. *Note: Make sure that the
size of the screwdriver is below 4mm. when removing or tighting screw
, and its position should be at a 90
degree angle from the mainboard (
Figure 5b
).wo tab
4.
Carefully lift up the heat sink
off the computer by pulling the two tabs
.
h
A
7
6
5
4
3
2
1
6
B
C
Figure 5
Processor Removal
a. Remove the cover and
Iocate the heat sink.
b. Remove the screws in
the order indicated.
B. Heat Sink
•
7 Screws
a.
1
2
3
A
b.
5
4
6
B
6
C
C
7
Summary of Contents for w110er
