1942488
V1.0
2nd August 2021
Instruction Sheet Template - V1.1
–
Updated 23/11/2020
Installation:
The Argonaut Square can be installed either Ceiling or Wall Mounted.
•
Remove the four (4) screws holding the diffuser to the base.
•
Remove the four (4) screws holding the gear tray to the base.
•
Determine the cable access point. There are 2 locations on opposite sides of the fitting for cable
gland/conduit entry. Entry can also be from the back of the base. Drill out the desired cable entry
point.
Note: Only round cables are to be used with the cable gland for an IP65 seal. Keep cable
entry straight and tension free. Ensure all seals are tight.
min. wire diameter 7mm, max. 12mm.
•
Drill out 4 of the mounting points in the base (see image below).
•
Using the base as a guide, mark the 4 holes for mounting and one for mains access if using back
cable entry.
•
Mount the base using appropriate fixings and seal these fixings with appropriate sealant (fill any
additional entry points with same sealant also).
•
Route the power inside the base.
•
Connect the 240VAC (L,E,N) supply to the terminal block of the gear tray.
•
Install the gear tray to the base.
•
Apply power to the fitting and test per the instructions.
•
NOTE:
This luminaire (with reinforced insulation between control/LED terminal and AC Supply) contains non-
user replaceable light source
– to be replaced (if required) by the manufacturer or his service agent or a
similar qualified person.
Dimensions:
Driver Setting:
For non -SEN / -DD products
Trouble Shooting:
Below are a list of common problems and their possible causes.
Fault:
The LED Strip is not illuminated.
Check: A.C. is connected and is turned on.
Wiring connections between the LED Driver & LED Strips
