Clever airpro, User Manual, Page: 9 / 12

CARE / MAINTENANCE / STORAGE
Only use care products that do not contain traces of acids or petroleum and never use silicone-based products.
• Clean your iSUP thoroughly after every use with fresh water and mild soap to remove salt crystals, sandy
granules and other small dirt particles. Leave it to dry completely.
• Whenever you take your board out of the water and deflate it, allow time for it to air out and dry. Neither
the skin/hull or the inside chambers will suffer from water damage, but stagnant water could cause
mildew and a foul odour.
• Deflate the parts of the iSUP by removing the stoppers from the relevant valves and remove all of the air.
• Carefully roll the iSUP from the front removing any remaining air in the process.
• Store your iSUP in a clean and dry place away from direct sunlight and somewhere with no great
temperature fluctuations. Pay attention to the fact, that the iSUP is not wrinkled but lays flat, and keep
well out of the reach of rodents.
• All inflatables are sensitive to cold. The iSUP should never be unfolded and inflated at a temperature
under 7°C!
• If the atmospheric pressure increases under the blazing sun, this must be compensated by releasing
some air from the craft.
• Try to ensure that the iSUP (particularly when inflated) does not come into contact with stones,
gravel or sharp objects, and that it is not dragged or pulled along the ground because
this can damage the iSUP‘s skin.
• Only insert suitable pump adaptors into the valve. The wrong type of pump adaptor can damage the
valve and void your warranty.
REPAIRING YOUR iSUP
You should not attempt to repair large damaged sections by yourself. You can repair small areas with the
enclosed repair kit.
1. Deflate the iSUP completely and clean the area to be repaired thoroughly. Roughen up the damaged
area surrounding the hole or tear with a fine sand paper.
2. Cut a patch large enough to cover the damaged area with enough excess to overlap the
damaged area by at least 1.25cm on all sides.
3. Apply a high strength glue (not supplied) to the iSUP as well as to the patch.
Leave to dry for approx 5 minutes.
4. Press the patch down firmly using a soft cloth. Make sure that you are working on a flat, even surface.
Remove any air bubbles with a rounded object, gently pushing the bubbles in an outward direction.
5. Always wait at least 24 hours after a repair before pumping up the iSUP once again.
- Perform all of your repairs in a well-ventilated area.
- Avoid inhaling glue vapours.
- Avoid contact with the skin or the eyes.
- Keep all repair materials (glue, solvents, etc) away from the reach of children.
- Repairs cannot be undertaken to the seam welds.
Only the manufacturer of the board should perform repairs to the seam welds.
DISPOSING OF YOUR iSUP
Please dispose of the product and packaging in an environmentally friendly manner, separating different
materials for recycling as required! Dispose of this item through an authorised disposal company or through
your local waste disposal facilities - ask your local authority for information if further guidance is required.
Ensure that you comply with all regulations currently in force.
9
CARE / REPAIR / DISPOSAL