• Free-standing:
If the unit is to be free standing, it is strongly advised that the four low-profile rubber
feet (supplied) be attached to the underside of the unit close to the dimpled mounting
holes. This will help prevent the unit sliding about and also stop any surface on which
it is placed being marked.
• Wiring:
All connecting cables should enter the unit via the black 16mm ‘blind’ grommets
located in the sides of the unit. These blind grommets are designed to be pierced
by a suitable tool to allow the cables to pass through them. These grommets should
always be removed from the case before attempting to make any form of hole in
them which will prevent damaging the circuit board and any existing wiring.
Safety note:
To prevent injury, extreme care must always be exercised when using
any sharp or pointed implement to pierce these grommets. Alternatively, the blind
grommet can be removed and replaced with a standard 16mm ‘open’ grommet or
any other form of suitable cable entry device if deemed more appropriate (e.g. M16
cable glands, etc).
Note:
It is strongly advised that the unit installation is fully functionally tested using
the supplied memory stick before replacing any of the files with new ones.
If you have any concerns regarding the installation of this unit please contact our
technical department.
7
Installation procedure:
• Important:
• Please read the Important Notes section at the beginning of these instructions
before installing this device.
• Do not connect power to the device until all the installation wiring and all the
connections have been completed.
The LB-5A is supplied in a painted metal enclosure that can be used as a
free-standing unit or secured to a flat surface by means of the four dimpled mounting
holes located in the corners of the base of the unit. To gain access to the unit, unscrew
the four lid retaining screws and remove the lid.
• Permanent Fixing:
Important note: When permanently fixing the unit to a surface the circuit board must
first be removed from the base by unscrewing the six mounting screws which will
give full access to the mounting holes. Attempting to secure the unit with the circuit
board still in place could lead to inadvertent damage to the unit and invalidate the
warranty.
6
Circuit Board
Mounting Pillars
Cable entry
16mm blind
grommets
Dimpled
mounting
holes
Rubber feet
position
