成Installation Guide_PV-ezRack_ezShade 2.0_AU_V1.0
1/10 Duerdin Street, Clayton VIC 3168 Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
17
page
of 19
成Installation Guide_PV-ezRack_ezShade 2.0_AU_V1.0
1/10 Duerdin Street, Clayton VIC 3168 Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
16
page
of 19
Installation Instruction
5.4.2
According to the Figure, place the first row of PV Module on the Water Guide Rail60 one by one. The order of
the PV Module is from low to high, and from left to right as shown in Figure 19.
Figure. 19
Installation Instruction
Note: Make sure each row of PV Module is without
gap, PV Modules are attached closely with the
Rails, and the ends of PV Module are aligned. Then
fasten Inter Clamps and End Clamps as shown in
Figure 20.
Recommended torque for M8 bolts is 18-20N·m
Horizontal and vertical aligned
Figure. 20
Without gap
5.5.1
Slide two sets of Corrugated Clamps into the bottom of the Gutter, and do not fasten the bolts as shown in
Figure 21.
5.5 Gutter Installation
Figure. 21
Figure. 22
5.5.2
Put the Rubber Ring into the Gutter and plug the bottom slot. Ensure the Rubber Ring is aligned with the ends
of Gutter. Glue evenly the connection as shown in Figure 22
The effect of installation among Gutter, Corrugated Clamp and Rubber Ring as shown in Figure 23.
Figure. 23
