Page 13
Press the outer lens onto the mushroom-shaped studs.
(6) Close the lens frame
again.
Hook the frame back in the latch and close.
Figure 3:
Replacing the inner lens using the installation tool
8.3 Replacing the helmet suspension
Carefully remove the helmet suspension from the holder (see also Figure 2).
The clips hold the helmet suspension in place. The angled tab must point toward the inside of the helmet.
When fitting the new helmet suspension, ensure that the chin strap is at the front.
8.4 Cape
Follow this procedure if the cape is soiled or needs to be replaced.
(1) Remove the cape.
* Open the buckle on the cape belt by pressing the small lever and pull-
ing the belt out.
* Remove the cape from the helmet.
(2) Attach the new cape.
* Put the spring that is sewn into the cape into the slot in the helmet (the
cape seam must face backwards).
* Slide the cape evenly into the slot until all of the spring is in the slot.
* Position the belt so that the buckle is opposite the lens frame latch
and the end is facing backwards.
* Pull the belt through, check its position and tighten the ratchet.
