ENGLISH
Fuses: replacing
! WARNING
1HYHUXVHDIXVHZLWKDKLJKHUDPSHUDJHWKDQVSHFL¿HG
The fuses can only be replaced by an TENNANT service centre or by technical personnel authorised
by TENNANT.
Lift the tank, disconnect the battery wiring connector from the electrical system or unplug the power
cable, remove the cover (Fig. 18-Ref. 1) to access the fuses.
Battery maintenance and charging
! INFORMATION
Before charging the batteries, remove the electronic key from the instrument panel.
! DANGER
Do not check the batteries by sparking.
7KHEDWWHULHV:(7JLYHRႇÀDPPDEOHIXPHV3XWRXWDOO¿UHVDQGKRWHPEHUVEHIRUHFKHFNLQJRUWRSSLQJXSWKHEDWWHU\OHYHO
! DANGER
Perform the operations described below in a ventilated area.
! WARNING
When charging the batteries, the tank must be lifted and kept open, to allow correct ventilation of the battery compartment.
! WARNING
,QWKHFDVHRIJHOEDWWHULHVXVHDVSHFL¿FFKDUJHUIRUJHOEDWWHULHVRQO\
! WARNING
To avoid permanent damage to the batteries, do not run them down completely.
! WARNING
Charge the batteries as instructed in the battery charger manual.
Disconnect the connectors at the end of charging.
! DANGER
Before releasing the screw ring on the tank opening cable, which is only permitted for battery installation/replacement and for checking/
restoring the level of sulphuric acid solution, make sure that the machine is standing on a perfectly horizontal surface.
$IWHUFRPSOHWLQJWKHDERYHRSHUDWLRQVKRRNWKHVFUHZULQJLQWRWKHORRSLQGLFDWHGE\WKHEODFNDUURZVHH¿JXUHEHORZDQGVHFXUHWKH
VFUHZRIWKHFDUDELQHUZLWKDKH[DJRQDOVSDQQHUVRWKDWLWFDQQRWEHRSHQHGPDQXDOO\DIWHUZDUGV
“ONBOARD” battery charger:
Ź
7XUQWKHPDFKLQHRႇ
Ź
8QSOXJWKHEDWWHU\FKDUJHUIURPWKHVRFNHW¿JUHI
Ź
Plug into the mains socket.
Ź
Start the recharge cycle.
Ź
The display will show when the recharge cycle ends, see
“Display alarms”
Ź
At end of the recharge cycle, unplug the cable from the power socket.
19
2
BATTERY CHARGER ON BOARD
1
18
22
