Remove the cap from the ECOGUM chemical bottle.
Insert the ECOGUM solution bottle into the square hole in the unit.
Screw the black cap onto the bottle (which is attached to the unit by a tube) and make sure
the tube is pushed as far down as it will go into the bottle.
Screw the 2 ECOGUM LPG gas bottles onto the gas valve manifold ensuring that it is tightly
connected and place these into the unit.
Turn the 2 gas valves on.
Replace the lid securely by the 2 clips either side to ensure pipes/cables are not snagged.
Screw a brass or nylon gum removal brush onto the end of the nozzle of the Lance.
Ensure that the battery has been fully charged before each use.
Place the brush on the piece of flattened gum and wait 5-10 seconds.
Agitate the flattened gum with the brush until you see it disintegrate by using circular
motions – do not scrub or apply pressure. The weight of the lance with agitation is all that
is required.
Remove the Ecogum PXR1 lance from the gum and use a broom to sweep across the area
to ensure the gum has been destroyed or if further cleaning is needed.
As gum deposits are all different there will be varying times taken to destroy each piece.
Turn the red switch of which will isolate the machine.
Remove the Gas and Chemical bottles from the Ecogum system.
Turn the switch on to drain the unit until there is no fluid coming from the nozzle at the end
of the lance.
Turn the red switch off so the pump is no longer working.
Make sure the speed controller is at zero (0).
Turn the pump/gas/fan on by pushing the red switch on the right hand side of the rucksack
and then after 5 seconds push the red starter button until you hear the unit ignite.
The unit will take about 3 minutes to heat up.
Once the unit is up to temperature turn the speed controller to number one (1). (¼ past 12)
A small adjustment may be required on the speed controller depending on what type of
surface you are removing the gum and how much fluid is required.
Before operating the ECOGUM PRX1:
Turning on the ECOGUM PRX1:
How to Remove Gum:
Turning on the ECOGUM PRX1:
Put the ECOGUM PRX1 on and adjust to fit the operative.
Summary of Contents for GUMPAK
Page 7: ......
