CleaverBrooks Master Panel 8, Operation Manual

Page: 30 / 60

Section 3 — Commissioning Master Panel 8
3-4 Part No. 750-375
C. I/P ADDRESSING (MASTER PANEL)
To set the Master Panel Ethernet configuration, first go to System
Configuration. Observe the screen warning: Lead/Lag control will not
function while in system configuration and the master panel firing
rate control will be forced to manual. Changing Ethernet settings may
cause a loss of communication.
Press <Master Panel Ethernet Config> for the following screen:
On this screen the IP Address, Subnet Mask, and Gateway are set for
the Master Panel PLC. A help screen is available. When settings are
complete, press <Configure PLC Ethernet> to confirm. This will
bring up the following window: