16
11. Troubleshooting
PROBLEM
POSSIBLE CAUSE
The red “Run” light remains constantly on.
• Please call service immediately.
Cabinet is not cold enough.
•
Check the temperature control setting.
•
External environment may require a higher setting.
•
The door is opened too often.
• The door is not closed completely.
• The door gasket does not seal properly.
•
Turn unit off at the powerpoint for 20 minutes to
reset. Turn on and set temperature.
•
Sensor or condensor failure. Please call service
immediately.
Turns on and off frequently.
•
The room temperature is hotter than normal.
•
A large amount of contents has been added to the
cabinet.
•
The door is opened too often.
• The door is not closed completely.
• The temperature control is not set correctly.
• The door gasket does not seal properly.
Vibrations.
• Check to assure that the cabinet is on level
The cabinet seems to make too much noise.
•
The rattling noise may come from the flow of the
refrigerator, which is normal.
•
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerator in your cabinet.
•
Contraction and expansion of the inside walls may
cause popping and crackling noises.
• The cabinet is not level.
Water leaking out from under the cabinet.
•
Humidity discharge tray is overflowing (page 10).
•
A large amount of contents has been added to the
cabinet.
•
Humidity level is set too low.
•
Excess humidity in cabinet. Empty water from
humidifier reservoir.
•
Install additional drainage pipe to an external
waste or drain point.
Excessive mould growth or sticky surface on meat.
• Humidity level is set too high.
•
Excess humidity in cabinet. Empty water from
humidifier reservoir.
If you have any questions or have an error not outlined above,
please call our service team on 0418 139 409 immediately to
discuss.
