ClearWater CD15/O2, Installation & Maintenance Manual

Page: 5 / 36

4
IMPORTANT SAFETY INSTRUCTIONS -
When installing and using this
electrical equipment, basic safety precautions should always be followed, including the following:
1.
READ AND FOLLOW ALL INSTRUCTIONS.
2.
SAVE THESE INSTRUCTIONS.
3.
All electrical connections should be made by a licensed, qualified electrician.
4.
Before attempting any electrical connections, be sure all power is off at the main circuit breaker.
5.
Install all electrical equipment at least five feet from any open body of water using non-metallic plumbing.
6.
Install check valves and a vacuum break to prevent water from contacting the electrical equipment.
7.
The electrical supply for this product must include a suitably-rated switch or circuit breaker to open all
ungrounded supply conductors to comply with Section 422-20 of the National Electrical Code, ANSI/NFPA
70-1987. The disconnecting means must be readily accessible to the operator(s) but installed at least five
feet from any open body of water.
8.
Be sure to bond (ground) the system using the copper bonding lug on the bottom of the ozone generator. The
system should be bonded with solid copper wire conforming with all local, state and national electrical codes.
9.
The system should be sized appropriately for its intended use by a qualified professional familiar with the
application. This equipment must be validated by the manufacturer for its intended use.