ClearView IPD-81A, Operation Manual

Page: 96 / 143

91
Figure 5-67
Step 2
Check “Enable” to enable the function of scene changing.
Step 3
It is to set the parameters of scene changing, please refer to the following sheet for more details.
Parameter Function
Working Period
Note:
It is to set the alarm period, it can enable alarm event only during the
period range which has been set.
1. Click “Setup” and the system will pop out the interface of “Working
Period”.
2. It is to set working period according to the following methods:

You can input time numerical value or press the left mouse button to
drag on the setup interface to set.

There are six periods to be set every day, select the check box in front
of the period, and then the period is valid.

Select week number (it selects Sunday by default, if it selects the
whole week, then it means the setup can be applied to the whole
week, you can also select the check box in front of the week number
to implement independent setting for some days).
3. Click “Save” to complete the setup of working period.
Record
Check it and so when alarm occurs, system will auto record. You shall set
record period in Storage>Schedule and select auto record in record control
interface.
Record Delay System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
Relay out Enable alarm activation function. You need to select alarm output port so
that system can activate corresponding alarm device when alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm ended. The
value ranges from 10s to 300s.
Send Email
If you enabled this function, System can send out email to alert you when
alarm occurs and ends. User can set email address in Network>SMTP.