60
Figure 5-32
5.2.3 PPPoE
The PPPoE interface is shown as in Figure 5-33.
Enter the PPPoE username and password which are provided by ISP (Internet Service Provider), and
click “Enable”. The network camera will automatically establish network connection in the mode of
PPPoE after it is enabled, after it is successful, the IP of the “IP Address” will be automatically modified
into the dynamic IP address of the acquired WAN.
Note:
After PPPoE dial-up is successful, it needs to log in the device via the IP which is set before dial-up; in
the PPPoE setup interface, it will display the registered IP address, and then it can visit the IP address
via client.
Please disable UPnP when clicking PPPoE enable, which is to avoid causing influence to PPPoE dial-
up.
Summary of Contents for IPD-81A
