ClearView IP-93A, Operation Manual

Page: 136 / 139

6
'HYLFHLVOHDNLQJZDWHU
Solution 1: Users dismantled the front cover and rear cover by themselves, which were not installed
properly.
Solution 2: The front cover glass is strongly pressed or crashed.
Solution3: The waterproof plug of rear cover is loose.
,3&IDLOHGWRUHFRJQL]H6'FDUG
Solution 1: Check if the card slot is loose.
Solution 2: Check if the SD card in the computer is recognizable and there is no abnormality.
&RQILJLQIRLVPLVPDWFKHGZLWKUHDOVLWXDWLRQDIWHU,3&ZRUNLQJIRUD
ZKLOH
Solution 1: refresh the interface.
Solution 2: It is caused due to the modification of IPC config; it doesn
’
t belong to the IPC problem.
Users can check what platform manages IPC or which device that the rear end is
connected to. They can use check the exact reason by adopting separated checking
method. Currently the PSS client and soft decoder can modify the Baud rate of some IPC,
which leads to a situation where the IPC is out of control.
3RZHUDGDSWHULVXQVWHDG\
Solution: The high and low temperature environment is from 0
ć
to 40
ć
for general power adapters,
the power supply will become unsteady if the adapter is beyond this range. Therefore, it is
necessary to change to industrial power adapter.
6'FDUGIDLOHGWRVWRUHYLGHR
Solution 1: Check if the SD card status is set as read only status, if so; you need to change it to
read/write status.
Solution 2: Check if the SD card can be detected.
Solution 3: Check if the SD card has been damaged.