17
CLEARSPAN
™
COLD FRAMES
Revision date: 12.29.08
OPTIONAL MAIN COVER INSTALLATION WITH ROLL-
UP SIDES (ADDITIONAL PURCHASE REQUIRED)
Shelter shown may differ than the actual model.
Ribbon Board
U-Channel
Shelter shown may differ than the actual model.
Ribbon Board
Rafter
U-Channel must remain
below the curve of the rafter.
INSTALL POLY LATCH U-CHANNEL
For a roll-up side application,
attaching the ribbon board to
the rafters and then attaching the poly-latch U-channel to
the ribbon board is recommended for the best results.
Gather the parts:
Aluminum U-Channel (supplied by customer)
•
Ribbon board (supplied by customer)
•
Tek screws (supplied by customer)
•
Measure the desired height to identify the top of the
1.
roll-up sides.
NOTE:
For the roll-up side panel to function properly,
the poly-latch channel attached to the sides of the
frame must remain below the curve of the rafter.
Attaching a ribbon board (not included) to the rafters
and then attaching the poly-latch U-Channel to the
ribbon board is recommended for the best results.
Consult the diagram below for clarification.
Attach one section of the poly latch U-channel to the
2.
side of the frame using Tek screws. Attach U-channel
flush with the outside edge of the end rafters.
NOTE:
Ribbon board and baseboard (recommended)
shown in the diagram above
are not included
and are
supplied by the customer.
NOTE:
The single poly latch is attached to the sides
and tops of the end rafters.
Continue to attach the U-channel sections to the rafters
3.
(or ribbon board if used) and work toward the other end
of the frame. Cut the last section of U-channel to the
required length so that it is flush with the edge of the
end rafter (if needed).
Repeat these steps for the remaining side.
4.
After
5.
attaching the U-channel to the sides of the frame,
use Tek screws to attach the single U-channel to the
top edge of the end rafters.
Insert shows the installation of poly latch U-channel on
top of an end rafter. The poly latch U-channel will bend
with the curve of the rafter as it is attached.
Continue to attach the U-channel until it has been
6.
installed on the top of
both end rafters
.
Dashed line
represents the
U-channel.
Location of the side runs of U-channel and ribbon board.
Top edge of the end rafter
