13
CLEARSPAN
™
GARDEN CANOPIES
Revision date: 01.04.12
NOTE:
Allow a few inches to remain between the end
of the cover and the ratchet.
At the main cover ends, locate the black straps in the
9.
bonnet portion of the cover.
Using the straps as guides, fasten ratchets to the
10.
outside of the end rafter legs using Tek screws.
Attach the remaining ratchets to the sides of the frame
12.
a few inches below the main cover.
NOTE:
Refer to the Quick Start Guide for ratchet
placement on different length shelters. Use the cover
conduit and the strap as guides to position the ratchets
at the proper height.
Attach side ratchets immediately across from each
other on the same rafter.
Toss the ropes over the frame and pull the cover into
7.
position. One person is required at each rope.
Center the cover end-to-end and side-to-side.
8.
Ropes
NOTE:
Diagram shown without optional side or end panels.
INSTALL COVER (CONTINUED)
After attaching each side ratchet, cut a slit through the
13.
main cover pocket above each ratchet.
Insert a 3' section of strap though the slit and around
14.
the cover conduit for each ratchet.
Actual shelter may be a different length than shelter shown.
Ratchets
Tek
Screw
Ratchet
Main Cover
Thread the strap ends into the ratchets and tighten
11.
slightly.
Do not fully tighten at this time.
