CLEARSPAN
™
JUBILEE TENTS
8
Revision date: 05.19.09
ASSEMBLE THE JUBILEE TENT COMPONENTS
NOTE:
Assistance is required to assemble the tent.
RAFTER ASSEMBLY
Gather the parts:
• Rafter pipe (#190S099D)
• Rafter pipe (#190S099)
• Rafter pipe (#190P0825)
• Rafter pipe (#190P095D)
• Rafter pipe (#190P030D)
• Rafter pipe (#190P00575)
Each rafter assembly will consist of two (2) pipes. Consult
the chart below to verify the correct pipe lengths.
Rafter Assemblies
Rafter Type
Pipe Lengths
Number of
Rafters
Base Rafter
19 190P075D
11
Lower Base Rafter
1 190P0825
10
Side Rafter
19 190P095D
6
Mid Rafter
190S099 (2) + 190P00575
2
Hip Rafter
19 190P030D
16
NOTE:
Only the lower base rafters and mid rafters are
assembled with190S099 pipes. All other rafters are
assembled with a 190S099D pipe. Keep the different rafter
types separate for easier assembly.
Rafter Assembly Procedure
1. Select the two (2) pipes needed to assemble a
particular rafter (see chart above) and arrange these on
a flat surface.
2. Slide the swaged portion of each pipe into the end of
the plain pipe that does not have holes. Position drilled
bolt holes at each end of the assembled rafters.
FRAME ASSEMBLY
Gather the parts:
• All rafter assemblies
• Leg pipe (#190P094D)
• Crown Coupler (#103931)
• Corner Coupler (#103933)
• Side Coupler (#103935)
• Hip Coupler (#103936)
• Short Cross (#10015808)
• 3-Way Open Corner (#10015608)
• Short Tee Swivel (#105944)
• 1/4" Carriage Bolts and 1/4" Nuts
• Tek Screws and Duct tape (customer-supplied)
Frame Assembly Procedure
When connecting the rafters to the coupler fittings, use the
first/outermost hole in the coupler fittings to secure each
rafter with a carriage bolt and nut.
When placing a carriage
bolt and nut, position bolt
as shown below to prevent
damage to cover.
ATTENTION
: Once the holes of the rafters and the
couplers have been aligned and secured with a carriage
bolt and nut, secure each rafter pipe connection with a Tek
screw.
Do not connect with a Tek screw until rafter pipe
has been secured.
Make sure the head of the Tek screw is
drilled in a position where it will not contact the main cover.
The following steps are only a suggested procedure for
assembling the frame. Regardless of how you choose to
assemble the tent, however, you must follow Step 6 when
assembling the hip rafters, as it is the only way to properly
fit the frame together.
