13
CLEARSPAN
™
EZ-GROW GREENHOUSES
Revision date: 09.12.08
2. Assemble two main cover conduits. Each conduit
assembly consists of one (1) 52" swaged pipe and one
(1) 68" plain pipe with Tek screw used to secure the
joint.
NOTE:
Duct tape Tek screws to prevent damage to
main cover pocket.
These cover conduits are inserted into the pockets
sealed along the sides of the main cover. The conduits
are used to tighten and secure the main cover.
3. After assembling the cover conduits, locate the main
cover and unfold it on a clean, smooth surface near the
frame.
NOTE:
Unfold the main cover with the inside surface
facing up.
4. Locate the cover ends with strapping and align with the
front and back of the shelter.
5. Insert the cover conduits into the pockets of the main
cover.
Cover
Conduit
Ropes
ATTACH MAIN COVER
Gather the parts:
• Main cover (with conduits inserted)
• Ropes long enough to reach over the frame (provided
by customer)
• Ratchets and plain straps
• Tek screws
• Box cutter or utility knife
Assembly Procedure
1. To pull the cover over the frame, attach a rope to each
end of the cover conduit. Wrap the rope around the
conduit a few times to prevent it from slipping off.
NOTE:
Depending on the length of the cover, it may
be necessary to attach additional ropes to the cover
conduit between the end ropes. If needed, cut a small
opening in the cover pocket and tie the rope around
the conduit. DO NOT cut through the main cover.
Cut
through the conduit pocket only.
2. With all ropes attached to the cover conduit, lift the
conduit and carry the cover toward the base of the
frame.
3. Toss the ropes over the frame and pull the cover into
position. One person is required at each rope.
PREPARE MAIN COVER (CONTINUED)
Cover Conduits
Cover
Ends w/
Strapping
WARNING:
To prevent damage to the cover and
possible serious personal injury, DO NOT attempt to
install the main cover on windy days.
