ClearCube Technology, Inc. 1505 Volta Dr. Suite 100 Cedar Park , TX 78641 (512) 652-3500 www.clearcube.com
Installation in A3100 chassis
Continued on next page
Inserting and
removing
The A3100 chassis (shown in
,
) provides redundant power, network ports (Ethernet
and dedicated PCoIP), and a USB port for all blades in a chassis.
The table below shows how to install and remove an A6108 blade from an A3100 chassis.
Step
Action
1
Open the chassis
front bezel
by pressing in on the
latch
on the upper-right side of the
chassis.
NOTE:
When pressing the latch to open the front bezel, hold the bezel with one hand to ensure that
the bezel does not fall.
2
From the top, pull the
bezel
toward you and lift up to remove it.
3
Hold the blade so the
D-shaped handle
in the front of the blade is upright and is facing you.
Align the
blade
with the
top and bottom guides
in the chassis and slowly insert the blade.
Result:
When fully seated, the blade is flush with the front edge of the bottom guide bracket.
NOTE:
There is slight resistance when blade connectors are inserted into backplane connectors.
4
Replace the
bezel
after inserting your blades.
5
Optionally, press the
power button
on the front panel to power on the blade.
6
To remove a blade after powering down, pull gently on the
finger pull handle
until the
blade slides out of the chassis.
NOTE:
Support both ends of the blade when you remove it completely from the chassis. Remember
to replace the chassis front bezel.
Page of
P/N <TBD> Rev A, 1.0.10.9.2020
6
15