D.) Installing the Unit
ООО "Бассейн-Сервис" – продажа и монтаж оборудования для бассейнов.
Тел: 8 (800) 700-65-50,
Turn off the pump and all valves. Disconnect all power
going to the motor, timer box or power source.
1.) Wrap Teflon tape around the two threaded male
adapters. You can also use “Liquid Teflon” a thread sealant
with Teflon. Always use plenty of tape to avoid possible
leaks. Screw adapters into the black flow cell chamber.
2.) If the pipe size where the flow-cell chamber
is being installed is 1 ½”, glue the two reducer
bushings (2” x 1 ½”) into the male adapters.
This step is not necessary if installing on two-
inch pipe.
3.) Locate a space to mount the black flow-cell chamber.
Always install on the
return line.
If possible, install the chamber after the filter, but it is not
required if there is not enough space. If necessary, you can re-pipe an entire section to allow proper room for the electrode
chamber or
ScaleBlaster
coil.
4.) Using a hacksaw or pipe cutter, cut out a
6”section
of pipe if
2” pipe
exists, or
6 ½”
of pipe if
1 ½” pipe
exists.
5.) In the area where the pipe was cut out, mount the black flow-cell chamber horizontally to avoid possible air pockets.
In other words, make sure the black flow cell is angled downward, so that when the electrodes are screwed into the cham-
ber, the wire connections are facing the ground and not the sky. The tee can also be installed on any vertical pipe. Do not
force pipes as they may snap. Always use PVC cleaner on the inside of the tee and the outside of the pipe before slapping
on the glue. Do not perform this step until you are absolutely ready to install the tee, as the cement will cure very quickly.
Installing the Electrode Chamber