22
Adjusting Microphone Gain
Some users talk louder/softer than others. To allow for this, microphone gain adjustment is available.
h
To increase microphone gain
– While holding down the
B button
, press the volume-up ▲ button as many
times as necessary to reach the desired level. The microphone gain increase can be monitored through side
tone, or preferably by someone else using a Communicator or at the base station.
h
To decrease microphone gain
– While holding down the
B button
, press the volume-down ▼ button as
many times as necessary to reach the desired level. The microphone gain decrease can be monitored through
side tone, or preferably by someone else using a Communicator or at the base station.
NOTE:
The mic gain setting will be indicated, in number format, by a voice prompt (typically, HS14 = 5, HS15
= 3, HS16 = 3). You will hear “Maximum” if you attempt to go higher than maximum mic gain. You will hear
repeating beeps if you attempt to go lower than minimum mic gain. Microphone gain will be saved in memory
and does not require readjustment each time the power is turned on. The Default setting is 3.
Adjusting BP410 Belt Pack Side Tone
h
To increase side tone
– Press the volume-up ▲ button while holding down the
A button
in the normal
operating mode.
h
To decrease side tone
– Press the volume-down ▼ button while holding down the
A button
in the normal
operating mode.
NOTE:
The side tone setting will be indicated in numbers by a voice prompt. Default setting is “Max”.
Using WH410 All-In-One Headset Lights-Off Mode
The Lights-Off mode can be used to avoid audience distraction from the lights on the All-In-One Headsets.
h
To operate in the Lights-Off mode, with the WH410 power off, press and hold the
B button
while you press the
POWER button
, and then release both buttons.
h
To get out of the Lights-Off mode, power the WH410 off and back on again without pressing the
B button
.
NOTE:
There is no side tone adjustment number for the All-In-One Headset.
Changing COMMUNICATOR
®
Batteries
When a Communicator battery becomes weak, a prompt in the ear piece will say “Change battery”.
Battery
Battery-release latch
(blue button)
Battery
RELEASE BATTERY
button
Press the
RELEASE BATTERY button
on the belt clip of
the pouch, and use your thumb to slide the battery from the
belt-pac.
NOTE:
You do not need to remove the pouch to remove or
insert the battery.
Remove the headset battery by pressing the blue
battery-release latch, and use your thumb to slide
the battery out.
Summary of Contents for HME DX410
Page 35: ...35 APPENDIX E AUDIO ROUTING DIAGRAM CH B 2WT04W CH B 4WT02W CH A 4WT02W CH A 2WT04W...
Page 36: ...36...
Page 37: ...37...
Page 38: ...38...