CleanStar VBP-BATT30, Instruction Manual

Page: 12 / 17

Cleaning the HEPA Pre-Motor Filter
Important, Please Note: The HEPA pre-motor filter will stop most of the tiniest dust
particles and airborne allergens from re-entering the air you breathe. In fact it stops
99.97% of all particles as small as 0.3 microns- many times smaller than a human hair!
Because of this incredible filtration performance, the
HEPA pre-motor filter will accumulate
many fine dust particles that are difficult to see. Be assured that the HEPA pre-motor filter
is doing the job. Clean the HEPA pre-motor filter after each use as described in this section
1. Remove the cloth bag from the canister. The HEPA pre-motor filter bag is located
underneath the cloth bag. To remove the HEPA filter, lift the form the sides of the HEPA
filter.
2. Vigorously ”TapClean” the
HEPA pre-motor filter on a hard surface to remove any
residual dust that might still be on the HEPA pre-motor filter.
3. You can wash the HEPA pre-motor filter by running it under the tap and allowing the
water to run on the dirty side at least once a month or when suction appears to be
decreased.
HOW TO CHARGE THE BATTERY PACK
When using the charger, basic precautions should always be followed, including the
following:
Battery and Charging Safety
To reduce the risk of electric shock, fire, battery explosion, or injury:
1. Basic information and warning for Cleanstar Battery and Charger are contained below.
For detailed usage and warning information, read the HOW TO CHARGE THE BATTERY
PACK carefully before using this unit.
2. Use only the Cleanstar Charger and Cleanstar Battery Pack supplied with the Cleanstar
Aerolite Flash.
3.
DO NOT expose battery pack to temperatures above 50°C. Never leave
battery packs in automobiles on hot days, where temperatures can be much higher
than the outside temperature.
4. DO NOT use or store vacuum or batteries in wet or moist conditions, or with flammable
or combustible materials.