- 8 -
CYCLONE CLEANING SYSTEM
The unit has a cyclone vacuum cleaner function without needing a dust bag. The sucked up dirt is forced
into the dust container. The air is cleaned by a washable permanent filter in the dust container, motor
protection filter and an exhaust air filter (HEPA filter).
Caution!
Never vacuum clean without a filter or with a damaged filter. The dust that is sucked up would force its
way into the device and damage the motor.
Clean dust / dirt in the dust container by an entirely new method ---it’s simple, clean and so easy.
Caution!
Over Heating Protection:
In order to avoid Motor Over-Heating caused by abnormal operation
（
Outlet of Ventilation is
blocked
…
..eg.,
）
this vacuum cleaner is equipped with Motor Over-Heating Protection. When vacuum
cleaner is suddenly stopped please wait for five minutes, then you may press power on/off switch to
restart the Vacuum Cleaner.
Emptying dust container
You can easily see with the transparent dust container when
it must be emptied.
1. Switch off the vacuum cleaner and disconnect the plug
from the mains. To do this always pull on the plug and
not on the cable.
2. You can pull the dust container together with the cleaning
system out of their anchoring with the aid of the carrier
handle on the dust container. Now lift out the dust container
and carry it to the waste bin.
3. A push button is located on the dust container that you can
use to open and empty it automatically (bottom-down technology).
To do this hold the dust container over your dustbin and
press on the empty button.
4. After emptying it clean the air filter again if necessary
(see also Cleaning the air filter below). After this rinse
out the dust container and wipe it dry. Make sure it is dry before use.
5. After this push the air filter cleaning system back into position in the cyclone vacuum cleaner until it
snaps into place. Your cyclone vacuum cleaner is now ready for use again.
